A camper conversion lets people to make use of a specially outfitted vehicle to sleep, sit, dine and travel. These vehicles provide one with a lot more traveling flexibility compared to the conventional recreational vehicles which are usually bigger and provide one with a larger number of accommodations at Great Living Homes. Among the most frequently undertaken conversion projects involves the changing of a van into a camper. Decide on a layout and design for your van. Go to a conversion-van manufacturer like Great Living Homes to get a number of design ideas and get to know the available options.
Get the van ready by getting rid of all the components that are not necessary for the conversion. Sketch out your layout for the furnishings of the interior. Get out the side panels on the interior then make use of masking tape to lay out all the sketched components.
Make use of rigid-foam insulation to insulate your van against noise, cold and heat. Use a utility knife to cut the material into the required shape. Stick the rigid-foam insulation to the panels’ interior sides and use expanding foam insulation to fill up the gaps and then put the panels back.
Use drawers to develop the main storage area from modular units. Stack up the units to get the height that you want.
Bolt to the floor your plywood platform. Ensure that the bolts you make use enough are long enough to go through the van’s bed thickness and the plywood.
Get plywood that has been finished using Formica on its edges and surfaces to develop your dining table. Put it on the bed’s or storage areas’ opposite side on the rear end.
Use the same techniques to come up with a counter surface with a sink. Below these develop storage for a cooler and two [portable water tanks, the same as the storage/ bed unit. Have a water pump installed below the sink and a container to collect all the water coming from the sink. Put this unit behind the seat of the driver.
Get two 6 volt RV batteries and connect them in series to get twelve volts. Link these batteries to a fuse box that contains four fuses; one for the exhaust fan, one for the water pump and two for lighting. Get two other batteries and link them to the car in parallel.
Get the exhaust vent fan installed on the roof or you could opt to get rid of one window. Finish up the conversion by getting padding and a carpet to cover up the camper floor with. Use drapery to conceal all your storage areas. Include any other accessories that you deem necessary.